Application of ‘Extrude’ tool (Join operation) Autodesk Inventor 2013 (with caption and audio narration)

Serial No. 191

Application of ‘Extrude’ tool (Join operation) Autodesk Inventor 2013 (with caption and audio narration)

 

  

Click the following link to get the model file: - http://bit.ly/2omKELY

 

 

Transcription of Video

1. Open the Part1 file.
2. A pre constructed sketch1 is visible in the design window.
3. Double click the Sketch1 in the browser bar.
4. Take the Offset of sketch, of the value 1/4 inch inside the enclosed profile.
5. Activate the extrude command from the marking menu.
6. Extrude dialogue box is visible in the design window.
7. The Profile selection button is active by default.
8. Select the profile enclosed by the yellow sketch and enter the distance value 3/8 inch.
9. Click OK to apply the extrude feature.
10. Open the visibility of Sketch1.
11. Activate the Extrude command once again from the Create panel.
12. Select the profile enclosed by the yellow lines and extrude it 1 inch in upward direction.